Other Network Architecture Subjects

i have 2 admin folks, but one of them is ONLY concerned with what goes on with the WAN / Remote offices. I'm currently having pages and emails sent out for all problems to both folks. Is there a way to send one person all alerts, but only send the ...

Hi guys,trying to find out how to activate Temperature Alarm onmy Cisco Catalyst 4006 using Sup 3 engine. Would liketo configure certain threshold temperature for auto shutdownto avoid module hardware damage because of inconsistenttemperature. I did ...

Hi dear reader,Here's something I've been looking at all last week, and I'm stuck.I've got two Cat 6009's running native IOS connected to each other through a channelised E3 on a FlexWAN module.I need to bridge at least three VLANs from one C6000 to ...

All, I have a descision to make.Should I use Auto RP or BSR for dist of RP mappingsAutoRP AdvantagesCan be used with admin scopingAutoRP DisadvantagesNeeds sparse-dense pimBSR AdvantagesCan run in sparse modeopen standardBSR DisadvantagesCannot be r...

Hi,I have 3662 at zonal office which is connected to 7513 routers at zonal office. Our head office has 2 wan routers doing wan aggregation for all the zonal office.Two E1 links coming from each head office wan routers and connected to zonal office w...

Hi there,I have many 2900XL switches that need to be configured for NTP. We have an NTP server (NTP1) that recieves its time feed from an external clock, but I cannot seem to get the switches to pick up this.Any help with the config would be great,Th...

I have a 6509 with 2 msfc cards and would like to setup dhcp for 10 vlans. We set up ip helper addresses on the vlans and dhcp is working but I am seeing duals broadcast because we have the configs the same on both msfc cards. Is there a differant wa...

Is it possible to setup two Frame Relay circuits connecting to different CSU/DSU interfaces on a 2621 Router to be load balanced or bundled? We are wanting to use the same IP block but just have twice the bandwidth.Thanks.

Question: What changes in behavior occur when specifying multipoint vs. poin-to-point on a sub interface in Frame Relay. The reason for my question is that I am reviewing someone else's config and I noticed that they are specifying multi-point on the...

Hello friend, Two sites conneted via PSTN using sync modems. I am able to ping across for 20 seconds after i reboot the routers and the sync modem. After 20 seconds ping times out. Any troubleshooting tips would be highly appr...

My local area network contains approx. 2500 nodes. The topology part of cisco works works great picking up all the switches and router. however, the user tracking only picks up IP addresses from certain types of switches. It will gather info from ...

Hello,I am fairly new to Cisco products. I have been asked to make sure our 2651 routers are able to pass DHCP to our core sever. After seardching I could not detrermine how to configure or to see if they are already configured to pass DHCP.Any help ...

We're running an ATM network based on LS1010 switches.For resilience each site has two parallel WAN links, terminated in separate switches both at the central site and at each site.For one site we have several SoftPVCs for video transport.The site ha...

Hi,What does these lines mean? Thanks.set logging server facility local5set logging server severity 5