i received %CI-2-ENVCRIT: -12 Voltage measured at -6.43 from 7513
here's the show environment output:
WLM-RT7513-01#show environment all
Arbiter type 1, backplane type 7513 (id 2)
Power supply #1 is 1200W AC (id 1), power supply #2 is 1200W AC (id 1)
Active fault conditions: none
Fan transfer point: 1%
Active trip points: none
15 of 15 soft shutdowns remaining before hard shutdown
1
0123456789012
Dbus slots: XXXXXX
card inlet hotpoint exhaust
RSP(6) -117C/-17 -113C/-17 -112C/-16
RSP(7) -117C/-17 -114C/-17 -112C/-16
Shutdown temperature source is 'hotpoint' on RSP(6), requested RSP(6)
+12V measured at 6.50
+5V measured at 2.75
-12V measured at -6.53
+24V measured at 12.83
+2.5 reference is 1.32
PS1 +5V Current measured at 0.00 A (capacity 200 A)
PS1 +12V Current measured at 0.00 A (capacity 35 A)
PS1 -12V Current measured at 0.00 A (capacity 3 A)
PS1 output is 0 W
PS2 +5V Current measured at 0.00 A (capacity 200 A)
PS2 +12V Current measured at 0.00 A (capacity 35 A)
PS2 -12V Current measured at 0.00 A (capacity 3 A)
PS2 output is 0 W
WLM-RT7513-01#show environment last
RSP(6) Inlet previously measured at -117C/-178F
RSP(6) Hotpoint previously measured at -114C/-173F
RSP(6) Exhaust previously measured at -112C/-169F
RSP(7) Inlet previously measured at -117C/-178F
RSP(7) Hotpoint previously measured at -114C/-173F
RSP(7) Exhaust previously measured at -112C/-169F
+12 Voltage previously measured at 6.46
+5 Voltage previously measured at 2.73
-12 Voltage previously measured at -6.48
+24 Voltage previously measured at 12.73
WLM-RT7513-01#show environment table
Sample Point LowCritical LowWarning HighWarning HighCritical
RSP(6) Inlet 44C/111F 50C/122F
RSP(6) Hotpoint 54C/129F 60C/140F
RSP(6) Exhaust
RSP(7) Inlet 44C/111F 50C/122F
RSP(7) Hotpoint 54C/129F 60C/140F
RSP(7) Exhaust
+12 Voltage 10.90 11.61 12.82 13.38
+5 Voltage 4.61 4.94 5.46 5.70
-12 Voltage -10.15 -10.76 -13.25 -13.86
+24 Voltage 20.38 21.51 26.42 27.65
2.5 Reference 2.43 2.51
Shutdown boards at 70C/158F
Shutdown power supplies at 76C/168F
Restart after shutdown below 40C/104F
show version output:
Cisco Internetwork Operating System Software
IOS (tm) RSP Software (RSP-JSV-M), Version 12.2(8)T10, RELEASE SOFTWARE (fc1)
hardware issue?software issue ?
