Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
530
Views
0
Helpful
4
Replies

Help with CLI Sequences / Shortcuts

joeayala
Level 1
Level 1

‎10-16-2002 07:54 PM - edited ‎03-02-2019 02:08 AM

I am working with an 806 router. When recalling previously typed commands I can use ctrl+p (and ctrl+n to go forward) but when I use the Up arrow the router immediately performs the last command again (like typing the command AND hitting Enter). Is there a way to change this so that I can use the up arrow key to go through the commands that are in the history buffer?

Labels:
0 Helpful
4 Replies 4

deilert
Level 6
Level 6

‎10-17-2002 03:57 AM

If you are using a program like hyper term to connect you need to change your setting to use terminal keys as opposed to windows keys. it is under properties and the settings tab

0 Helpful

joeayala
Level 1
Level 1
In response to deilert

‎10-17-2002 04:34 AM

Thanks for the tip!

0 Helpful

joeayala
Level 1
Level 1

‎10-17-2002 12:43 PM

OK that didn't work. Switched setting to 'windows keys' but that only allows me to move up and see the previous hyperterminal lines it doesn't allow me to recall any commands. Any other suggestions to set the arrow keys to recall recently entered commands?

0 Helpful

deilert
Level 6
Level 6
In response to joeayala

‎10-18-2002 03:56 AM

It has to do with your terminal emulation. try setting it to ANSI

0 Helpful
Customers Also Viewed These Support Documents