How do i configure a Cisco 1701 ADSL to support Routing between two VLANs

[surendra_persaud]

Hi,

I have a Cisco 1701 ADSL Router which has ONLY One Ethernet Port 10/100. I would like to setup Routing between two networks.

If i purchase a 9-ports 10/100 Managed Switch (not sure which 1 as yet) that supports VLan tagging, could i configure the Switch so that Port 2 is for VLAN1 = 192.168.0.1 and Switch Port 3 for VLAN2 = 192.168.1.1. Now, how would i configure Switch Port 4 so that it can connect to the router ethernet port and what IP should I use. Likewise, how would i configure the router to route between the two VLANs.

Thank you,

Surendra

[thisisshanky]

The 1701 does seem to support Intervlan routing using dot1q and subinterfaces.

http://www.cisco.com/en/US/products/hw/routers/ps221/products_data_sheet09186a0080180fa9.html

Check this link for configuration. The link might indicate a 2600 router but it would be the same for 1701.

http://www.cisco.com/en/US/tech/tk389/tk390/technologies_configuration_example09186a00800949fd.shtml

HTH

Sankar.