About surendra_persaud

surendra_persaud · 12-19-2005

Hi,I have a Cisco 1721 Router in my possession, which I am assisting with its configuration. Prior to my input, I was told that this router was partially configured, however, it failed to boot after numerous restarts. This router in its boot process ...

surendra_persaud · 09-08-2005

Hi,I have a Cisco 1701 ADSL Router which has ONLY One Ethernet Port 10/100. I would like to setup Routing between two networks.If i purchase a 9-ports 10/100 Managed Switch (not sure which 1 as yet) that supports VLan tagging, could i configure the S...

surendra_persaud · 08-13-2005

Hi,I need advise as to if a Cisco 1701 ADSL router could support WIC-1ENET Card.My 1701 Router has WIC 0 as ADSL and WIC 1 as ISDN, could the ADSL card be replaced by a WIC-1ENET. I noticed ,that the cards seems to be rivet onto the back of the Route...

surendra_persaud · 12-22-2005

Hi,Thanks for your response, however, i cannot get into the Rommon Mode...As mensioned in my request for assistance, just as the router boots, it will display a freezing error line (see previous information) and remains the same....Regards,Surendra.....

surendra_persaud · 08-14-2005

Hi GP,Thanks for your helpful information on the WIC for Cisco 1701 ADSL Router. However, my other question is that WIC0 (ADSL) and WIC1 (ISDN) seems to be rivet onto the Router, there are no screws on it...I dont want to attempt taking out the card,...

Member Since	‎08-13-2005 07:05 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	5

User Statistics

User Activity

Cisco 1721 Router cannot boot pass the POST test.

How do i configure a Cisco 1701 ADSL to support Routing between two VLANs

Could Cisco 1701 ADSL Router supports WIC-1ENET Card.

Re: Cisco 1721 Router cannot boot pass the POST test.

Re: Could Cisco 1701 ADSL Router supports WIC-1ENET Card.