396
Views
0
Helpful
2
Replies
how to config trunk between router2511 and cat3524?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-04-2002 09:24 PM - edited 03-01-2019 07:55 PM
I made as follow on cat3524:
conf t
int fa 0/1
switchport mode trunk
switchport trunk isl
exit
====
And how to do on router 2511 ethernet 0?
Labels:
- Labels:
-
Other Networking
2 Replies 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-04-2002 10:31 PM
cisco2511 does not support ISL or 802.1Q encapsulation.
You can use 175x or 26xx,they support 802.1Q protocol.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-07-2002 04:03 AM
Check this URL out.
http://www.cisco.com/warp/public/473/50.shtml
Trunking over 10mb is probably not supported.
