how to configure a cisco box to send ospf traps

[hfukushi]

I have found CISCO-OSPF-TRAP MIB, but haven't found

any command in order to enable OSPF traps on a cisco box. Does anyone know the command to enable OSPF traps? Thank you in advance. -hiro

[krozier]

Hi Hiro,

Here is the infomation that I recieve from the Cisco.Com:

The current version of OSPF MIB supported on Cisco devices does not support SNMP traps. There are no SNMP traps required for this procedure.

I go this from the following weblink:

http://www.cisco.com/en/US/tech/tk869/tk769/technologies_white_paper09186a00801177ff.shtml#snmp_collect

Try this previous forum thread link on configuring Cisco routers to send syslog messages:

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1dd65fd0/0#selected_message

Hope this helps.

Kersean Rozier

Rate if helps.