Other Network Architecture Subjects

I have found CISCO-OSPF-TRAP MIB, but haven't found any command in order to enable OSPF traps on a cisco box. Does anyone know the command to enable OSPF traps? Thank you in advance. -hiro

I recently implemented QoS in my companies' network. I am in the process of developing a QoS troubleshooting training for my OPs Team. Do you have any sample problems, presentations or any sort of info that you wouldn't mind sharing?(BTW - I think ...

Has anyone ever gotten the GRE multipoint working, or in which scenarios is it applicable?. I will appreciate some sample configurations.

the supervisor engine SUP1A on the slot2 changes the status from standby to other. The Catalyst 6009 ist running the Boot Image file cat6000-supk9.7-6-7.bin.can someone help? Thankscat6009>sh moduleMod Slot Ports Module-Type Model ...

I have installed a WIC-1DSU-56K card into a Cisco 1721 router and the card came with a CAB-DSU-RJ45 cable. My telco tells me I require a RJ48S or RJ48C cable to connect to the Frame circuit. I read on a vendor site that the CAB-DSU-RJ45 is equivalent...

Is it possible to run two routers with HSRP and at the same time use the "ip load-sharing per-packet" command in the FE interface?

When I right click on a 3524 switch port in ciscoview I only get 'monitor' and 'clear all addresses' options. How can I configure the switch port? I already upgrade to the latest ios and installed the latest device patch on ciscoview.

I am preparing a 7204 router for a test and when I log into it the promtp says:Router(boot)>Then when I go into enable mode it's:Router(boot)#I have a 7204VXR with a NPE-300, a FastEthernet I/O controller, and a Multi-Channel DS3 port adapter.

Does anyone know if there is a release out there that supports setting the BW statement on your router asymetrically?With all the asymetric DSL out there, I'm looking for a way to trigger alerting when I peg my upload without generating alerts on my ...

Hi,cisco 3660 + NM-2CE1B + CAB-E1-PRImy configuration :router(config)#contro e1 3/0router(config-controller)#channel-group 0 timeslots 1-31router(config-controller)#no shutrouter(config)#int s3/0:0router(config-if)#ip add 10.201.2.1 255.255.255.252ro...

Our customer's CISCO2621XM is not recognizing their WIC-1DSU-T1 but it will recognize a WIC-1T. The WIC-1DSU-T1 is recognized in the older Non-XM CISCO2621 Router. Any thoughts? Do we need to replace the router or the WIC-1DSU-T1- or is there anoth...

How can I clear all the counters and logging info on the router without reloading it?Thx,C.

HiIs it possible to run GLBP in a Cat6500 with 2 Sup720 and SSO (running native mode ofcourse) as far as I can see this can not be done (yet).Best RegardsAnders NilssonUmeå Univ