I want to make multi vla in wlc

[ahmedabufayed]

Hi
Now I have a project in Packet Tracer
I Want to make multi vlan on WLC
So that every vlan have a different ip range.
I have researched and used the method through the interfaces in WLC but I feel that I have some errors in setting the interface by entering the values ​​incorrectly.
I will attach the files that explain the file and I ask you for help and thanks

[Julio E. Moisa]

Hi

You should create a trunk on the switch and use a native vlan, the same native vlan should be used on the WLC, i prefer do that via CLI. 

[ahmedabufayed]

I do this steps, but there ithe problem still

[Georg Pauwen]

Hello,

post the zipped Packet Tracer project (.pkt) file.

[Georg Pauwen · Accepted solution]

Hello,

the addressing looks good actually. The problem seems to be that the link connecting the WLC to the layer 3 switch needs to be a trunk link. I changed that setting, file attached.

interface FastEthernet0/3

switchport mode trunk

switchport trunk encapsulation dot1q

[ahmedabufayed]

Thank you much for your help

[RicardoArevalo3209]

Hello, I liked this topology but I can see that the laptop2 and the laptop5 can't connect to their respective wlans (std and guest) 

I want to know if there's a missconfig or something because the APs are working fine and are registered in the WLC but the laptops couldn't connect to the APs.

Thanks!