12-29-2003 01:33 AM - edited 03-02-2019 12:35 PM
Hi,
----------------------------------------------------
ignore-hw local-loopback
To disable the monitoring of the LL pin when in DCE mode, use the ingnore-hw local-loopback interface configuration command. To return to the default, use the no form of this command.
ignore-hw local-loopback
no ignore-hw local-loopback
-----------------------------------------------------
I didnt find this command in cisco router 2600 ver 12.0. The serial router interface works at 2Mb/s. When, there are many interruption in the patton modem,the serial interface become looped. Thsi command resolve my problem, but i didnt find it.
Thnaks for help.
12-29-2003 02:34 AM
Hello,
I think this command only works when your interface is in DCE mode (when the clock rate is set on PPP interfaces, or when the clock rate and interface type is set to DCE on Frame Relay interfaces).
Regards,
GP
12-29-2003 02:43 AM
Hello,
Thanks. It's OK. But, did you know another command to disactivate the loop of the interface? Or it is relatively to the modem ?
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide