ignore-hw local-loopback

e-mourad · ‎12-29-2003

Hi,

----------------------------------------------------

To disable the monitoring of the LL pin when in DCE mode, use the ingnore-hw local-loopback interface configuration command. To return to the default, use the no form of this command.

ignore-hw local-loopback

no ignore-hw local-loopback

-----------------------------------------------------

I didnt find this command in cisco router 2600 ver 12.0. The serial router interface works at 2Mb/s. When, there are many interruption in the patton modem,the serial interface become looped. Thsi command resolve my problem, but i didnt find it.

Thnaks for help.

Georg Pauwen · ‎12-29-2003

Hello,

I think this command only works when your interface is in DCE mode (when the clock rate is set on PPP interfaces, or when the clock rate and interface type is set to DCE on Frame Relay interfaces).

Regards,

GP

e-mourad · ‎12-29-2003

Hello,

Thanks. It's OK. But, did you know another command to disactivate the loop of the interface? Or it is relatively to the modem ?

Thanks