ip accounting

[psoltesz]

Hello,

I setup ip accounting on some interfaces on the router. I try to get accounting table with snmp queries, but i can only 512 entry from the accounting table. Is there any possibility to over write this limit?

Bye,

Peter

[Steve Fuller · Accepted solution]

Add the command "ip accounting-threshold x" where x is the number of IP accounting entries you want in the accounting table.

Be careful of the value you change this too as it will obviously consume free memory in the router.

Check http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps5207/products_command_reference_chapter09186a0080238b72.html#wp1121998 for further information on the command.

Regards