HI,I try to use Dell 1450 wireless USB adapter wich is WiFi certified and Cisco Compatible to connect our network over an Cisco 1231 AP. Other network adapters works well such intel 2100 or intel 2200 adapters. I can configure the DELL adapter same,...
Hi,Are there any role for numbers of drops of the output queue? Normally the packet drops used to avoid the congestion. Which number of drops are acceptable? How can i avoid or decrease the drops? Are there best method aside from increase the bandwit...
Hello,I setup ip accounting on some interfaces on the router. I try to get accounting table with snmp queries, but i can only 512 entry from the accounting table. Is there any possibility to over write this limit?Bye,Peter
hello!I suggest you the www.cisco.com/go/srnd site where can you find lots good documentation.The following link for qos you can find there http://www.cisco.com/univercd/cc/td/doc/solution/esm/qossrnd.pdfBye,Peter
Hello,On the Cisco APs possible configure VLANshttp://www.cisco.com/en/US/customer/products/hw/wireless/ps430/products_installation_and_configuration_guide_chapter09186a00801486a1.html with this technic you can setup VLAN for manage and other for a c...
Hi Antonio,I think you want to manage network equipments. Use VLAN1 or other VLAN for management purpose. The cisco switches use VLAN1 as nativ VLAN. On the switches the physical ports configure to VLAN100 or VLAN200 or any other. So you can securely...
I can imagine this situation that case if on the remote PCs not configured properly the default gateway.Or if your remote site has more router and the default router not this 2620, and the default route don't know the 1750's site..