11-07-2001 11:37 AM - edited 03-01-2019 07:17 PM
Hi folks!
A simple problem ( I hope so..) I've configured Cisco 2600, IOS version 12.1(6) with IP addresses for the 3 interfaces (e0,e1 and s0. When I enter the router rip command. The message displayed in "IP routing not enabled". Anyhelp would be appreciated.
11-07-2001 12:11 PM
Try entering "ip routing" in your config to see of that makes a difference.
01-08-2016 01:39 PM
tnx ggehle, the ip routing command resolved d isuue
11-29-2022 02:48 PM
thank you so much, one more time with arabic جزاكم الله خيرا
11-07-2001 12:41 PM
from config term
type "routing ip"
11-07-2001 01:04 PM
i meant ip routing
11-07-2001 03:31 PM
Remember
Without enabling (ip routing) your routing protocol will not work.
Can I ask why are you using RIP? or RIP2 ??
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide