Simple query. Does anyone know what BRI ISDN switch-type is used by the Brazilian Telco, Telemar.Thanks
Forum Posts
Resolved! Cat8K vs. N9k for EVPN DCI Solution
Hello all,I want to create a design for DCI of 3 locations. Direct fibre lines between the sites are available, howeverI am looking for an intelligent broadcast management. As OTV was an interesting but proprietary technologyI am now thinking of VXLA...
HelloOn company we have run dot1x and mab authentication.On a stack of of 3 C1000-48P-4G-L doesn't work dot1x authentication. Mab authentication works fine.On a standalone C1000-48P-4G-L with the same configuration as stack dot1x and mab works fine.S...
We have a new network setup as the attached diagram, and we want to use Cisco firewall and Cisco switch in this design, Please can you suggest the recommended and best L3 switch and Cisco Firewall with required configuration on L3 switch to be done t...
There is something went wrong in my config, but I cant find the problemTHESE ARE MY BASIC CONFIG:hostname Router1line console 0password passwd loginline vty 0 15password passwdloginlogging synchronousenable password passwdenable secret passwdservice ...
Hi everyone. I'm new to cisco and i was wondering if it's possible to connect a 1841 running IOS 12.4 to a mikrotik L2TP/IPSec server. The reason i do not wish to use Cisco as the server is because it is going to be used with a dynamic Public IP. TIA...
Just wondering if there was a situation where you would prefer one over the other?I know that AutoRP is Cisco Proprietary and relies on Dense mode to flood the mapping agent and candidate RP advertisements.But I don't know besides that, why you would...
Hi, ASR9k Show tech output available at 0/RSP0/CPU0 so Could you please help to fetch that logs from particular RSP path. RP/0/RSP0/CPU0:HNI.MC01#show tech-support ++ Show tech start time: 2018-May-29.134520.HaNoi ++ Tue May 29 13:45:20 HaNoi 2018 ...
HelloI am just wondering if there are any specific architecture recommendations for using a FVRF in DMVPN, perhaps to avoid the potential recursive routing issue when a tunnel learns the route to the destination via the tunnel itself.I know how to do...
We use our Cisco routers as DNS for the local site they serve.So basically, we have domains set up for internal DNS servers and public DNS servers, which then use lists to specifiy the details for urls or subnets which are used for internal.The 10.75...
Resolved! MPLS - Transition / Migration
Hello,Soon, within the next 6 months, we will be migrating to full a MPLS network. The plan is to put all our field offices on to MPLS.However it will occur in stages over several months. My pressing concern is how to connects six field offices to MP...
I need help with a pt project. Need someone to show me how to do it. Will pay for your time, obviously.
Does anyone recognize this brand of patch panel? It was installed by a contractor a while ago and I had a need to add more jacks to it but none of the RJ45 jacks I have fit. We have jacks that fit Leviton and Panduit, but no luck with these. It lo...
I'm not getting the point of vrf In tunnel when we use # (ip vrf forwarding ivrf) and (ip vrf forwarding fvrf) ?What is the use of # tunnel vrf FVRF. ?
Hola colegas, estoy comenzando mi primer trabajo como administrador de red, y me pidieron que creara un usuario de servidor taccacs+ con privilegios solo para ver los comandos show* en la red de Cisco, pero resulta que cuando inicio sesión en la red ...
