11-09-2016 10:46 PM - edited 03-03-2019 08:23 AM
Good Day
Can anyone assist me on IPService License for Cisco 3750 to enable full ip routing
Below find details :
NAMDRPHOST#sh license detail
Index: 1 Feature: ipbase Version: 1.0
License Type: Permanent
License State: Active, In Use
License Priority: Medium
License Count: Non-Counted
Store Index: 0
Store Name: Primary License Storage
Index: 2 Feature: ipservices Version: 1.0
License Type: Evaluation
License State: Active, Not in Use, EULA not accepted
Evaluation total period: 8 weeks 4 days
Evaluation period left: 8 weeks 4 days
License Priority: None
License Count: Non-Counted
Store Index: 0
Store Name: Evaluation License Storage
NAMDRPHOST#sh ver
Cisco IOS Software, C3750E Software (C3750E-UNIVERSALK9-M), Version 12.2(55)SE5, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2012 by Cisco Systems, Inc.
Compiled Thu 09-Feb-12 18:14 by prod_rel_team
Image text-base: 0x00003000, data-base: 0x02800000
ROM: Bootstrap program is C3750E boot loader
BOOTLDR: C3750E Boot Loader (C3750X-HBOOT-M) Version 12.2(53r)SE2, RELEASE SOFTWARE (fc1)
NAMDRPHOST uptime is 1 day, 4 hours, 47 minutes
System returned to ROM by power-on
System restarted at 07:02:44 sa Sun Oct 9 2016
System image file is "flash:/c3750e-universalk9-mz.122-55.SE5/c3750e-universalk9-mz.122-55.SE5.bin"
11-10-2016 02:31 AM
Hi
did you purchase the ipservices license or are you just trying to enable the evaluation ....4
Usage Guidelines
Use the license boot level command for these purposes:
This command forces the licensing infrastructure to boot the configured license level instead of the license hierarchy maintained by the licensing infrastructure for a given module.
This command takes effect at the next reboot of any of the supervisors (Act or stby). This configuration must be saved to the startup configuration for it to be effective. After you configure the level, the next time the standby supervisor boots up, this configuration is applied to it.
To boot the standby supervisor to a different level than active, configure that level by using this command and then bring up the standby.
If the show license all command displays the license as "Active, Not in Use, EULA not accepted," you can use the license boot level command to enable the license and accept the end-user license agreement (EULA).
The following example shows how to activate the ipbase license on the switch upon the next reload:
Switch(config)# license boot level ipbase
Command |
Description |
---|---|
license install |
Installs a stored license file. |
license save |
Saves a copy of a permanent license to a specified license file. |
show license all |
Shows information about all licenses in the system. |
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide