I wanted to use one of the standby 7507 for TFTP server. After I copied 1700 image to Slot0 the CPU usage hit 99%. The messages are below ;
Router#copy tftp slot0:
Address or name of remote host []? x.x.x.x
Source filename []? c1700-advsecurityk9-mz.123-8.T3.bin
Destination filename [c1700-advsecurityk9-mz.123-8.T3.bin]?
Accessing tftp://x.x.x.x/c1700-advsecurityk9-mz.123-8.T3.bin...
%Warning: File not a valid executable for this system
Abort Copy? [confirm]n
Loading c1700-advsecurityk9-mz.123-8.T3.bin from x.x.x.x (via FastEthernet0/1/0):
Router>sh proc
CPU utilization for five seconds: 99%/1%; one minute: 93%; five minutes: 79%
PID QTy PC Runtime (ms) Invoked uSecs Stacks TTY Process
1 Csp 6030F890 628 6731143 0 2584/3000 0 Load Meter
2 Mwe 600616F0 0 1 0 5780/6000 0 ATM_PVCTRAP
3 Lst 602F2FF0 14692424 3984923 3687 5632/6000 0 Check heaps
and then it drops again once the copy is finished..
Router>sh proc
CPU utilization for five seconds: 99%/1%; one minute: 93%; five minutes: 79%
Why is this happening ? Has anyone experienced similar thing ?
Serhat