ISDN Bonding

[sidharthar]

i need to bond two ISDN lines on two WIC ISDN cards (1750) dialing to a remote site( 2610 with 4 port ISDN NM) can you give me a sample config for this kind of a setup....

Thanks

[Philip D'Ath]

I suggest you go to www.cisco.com and search for ConfigMaker. It is a free download, and can help greatly with these tasks.

The below approach causes one circuit to kick in, and then a second should the amount of traffic require it (probably saving you some call charges).

The important bits for your config are:

interface Dialer 1

ppp multilink

dialer load-threshold 10

dialer-group 1

interface BRI 0

dialer rotary-group 1