Is it possible to have multiple default routes on a 2948g-L3 switch ? If so, will it serve as a redundant link ? ie will traffic only go through one link unless the link goes down .
Hello,Can anyone tell me the difference between mls and mls rp on a Cisco 6509 supervisor card?I've noticed that the sh mls status shows global mls ipx as enabled but sh mls rp shows ipx multilayer switching as globally disabled.Many thanks, Lee.Mari...
Could anyone tell me how ot use MRTG monitor router's sub-interface (Vlan traffic)? When I use cfgmaker to create cfg file, it only generates items for main interfaces. Is there any option needs be turned on for cfgmaker. I know it can be done throug...
Hi, I have cisco 3640 router with multi T1 lines running BGP. I have many web servers running and i want to limit the bandwidth of of these webservers. Though there are many third party bandwidth mangement solutions, is there any thing that can be do...
Hello all,I have a question about IOS used in catlist 3550 and 4000:From http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/rel6_3/config/qos.htm, I only see the configuration about WRR. There is no CAR/Shaping, WRED, Cos-DSCP-IPPrecedence ...
Hello,What can I do if passwords for switch console and for routing module msfc on 6509 have been lost?Will the configuration be lost? I need to have a contigency way to prevent the impact if happen in the future.What about C2600 and C3524?Thanks,Mor...
I need to download software then install gatekeeper for AS5300. I checked cisco website, it seems the procedure is:1. download callmanager to PC ?2. ??Please help me.Thanks!Lawrence
I'm trying to investigate RFC1918 addressed packets coming in on my internet connection. For this I set up policy routing on my serial interface to the provider. This is a frame relay PVC, an unnumbered interface if that matters. An extended acces...
We have cisco 7513 with 2*RSP4(64 DRAM 16 FLASH), VIP2-15(1 FastEthernet, 8 port Serial EIA/TIA-232), VIP2-40(1 FastEthernet, 8 port Serial V.35)IOS rsp-jsv-mz.112-7.PWhen I change (update) IOS from ver.11.2(7)P to ver.12.1(6) or 12.0(3)T VIP2-15 no...
I have setup NTP on our 7200 router. It is setup as NTP Master.The system clock gets its time from the system calender. I have the command "clock calender-valid" so it is supposed to be authoritative.My question is that the system clock very quickly ...
I am thinking about seperation the switch into 2 VLANs, however there is only one ethernet port to connect between the switch and the router. So only 1 VLAN can have connection to the router (i.e, internet connection). What can I do to allow both VLA...
To make it possible for a ISDN back-up circuit to come up automatical when the primary circuit goes to a down/down state, what configurations are needed on the Serial 1 interface (being used for the ISDN circuit). I appreciate any help. Thanks.
Can you run NAT on the same router that is also running BGP? If so, is the “ip nat outside” statement placed on each serial interface or the loopback? I can’t find any examples on Cisco site. Dave Tomblindtomblin@tsunamicomm.net
