limit the unequal cost balance on serial ports

[morriszhu]

With eigrp variance option, the unequal cost balance can be applied on the 2 serial ports of the router. But unequal cost balance is not needed for other ethernet ports of the router. How to limit it? thanks!

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.