Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
281
Views
0
Helpful
2
Replies

Line errors on a t1

peterson.dave
Level 1
Level 1

‎10-05-2004 05:41 AM - edited ‎03-02-2019 06:59 PM

I have a PRN circuit that is currently slowly incrementing input line errors. By slowly I mean 600 or so an hour. I have allowed the telco to test the line, they now say that they must go on site to test further. Is there anything I should know or watch out for when they get there? Does anybody have any idea what the cause could be?

Thanks for any help, I am fairly new to this type of setup.

Dave

Labels:
0 Helpful
2 Replies 2

chris.kemp
Level 1
Level 1

‎10-05-2004 06:24 AM

It sounds like a bad cable pair or other physical layer issue. Usually the tech will test and repair with the CO with little input from the user. When they're done, they turn it back over to the user to verify everything is working correctly.

0 Helpful

peterson.dave
Level 1
Level 1
In response to chris.kemp

‎10-05-2004 09:07 AM

Thanks for the reply. I was hoping it would just be something simple.

0 Helpful
Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card