Loading new ROMMON version on 3640

[ed.mcknight]

I need to load ROMMON 12.2 on a 3640 so it will work with a 2FE2W and IOS 12.3 or 12.4 I found a paper titled

ROM Monitor Download Procedures

But

"Note The commands show rom-monitor, showmon, upgrade rom-monitor, upgrade rom-monitor preference, rommon-pref are present in the Cisco 3700 series routers only. "

I have tftp'ed the image into the flash so all I need to know is....

What is the command to load the new rommon image?

HELP

Ed

[mchin345]

You can use the Xmodem command to load the Image on the router. Refer the following link on Xmodem Procedure for Downloading a Cisco IOS Software Image onto a Cisco 3600 Router for more information :

http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bfac.shtml#proc_3600

[ed.mcknight]

I had already found that page about loading the

"IOS"

image I need to load or flash the ROM "bootstrap" as you can see below from my sh ver the IOS is 12.1 but the bootstrap version is 11.1. I need a 12.2 or better bootstrap so the router can use a 10/100 network module.

IOS (tm) 3600 Software (C3640-I-M), Version 12.1(20), RELEASE SOFTWARE (fc2)

ROM: System Bootstrap, Version 11.1(20)AA2, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)