Other Network Architecture Subjects

Dear all,Excuse me but,please give me an advice asap.I'm considering about the following network. I'll configure the HSRP between the two Cat6506. And I want to use the teaming between the two Intel Giga NIC by using Intel PROSet.From the server,Cat6...

we are currently running igrp on all routers at HQ and 6 remote branches.We've just purchased new router with new software 12.3 which removes igrp.Is there a way that we can changeall remote router from igrp to eigrp WITHOUT physically going to remot...

i am trying to forward the RDP port to a terminal server inside my LAN. but things are not working for me. Router is 801 ISDN my config is.. -------------------------- version 12.1 no service pad service timestamps debug uptime service timestamps log...

During a competitive pilot against another vendor, it has been observed that a ping packet is lost each time the MSFC router has to re-ARP the next hop. With the other vendor, there is no ping lost. beside the fact that this is not a real problem, th...

i know that there are some security guru's out there. Here's what i need i'm running 4-5 different (CELLS) all connected through a fiber backbone and have several people who like to jump around from room to room and change their workstation ports to ...

I need to load ROMMON 12.2 on a 3640 so it will work with a 2FE2W and IOS 12.3 or 12.4 I found a paper titledROM Monitor Download ProceduresBut "Note The commands show rom-monitor, showmon, upgrade rom-monitor, upgrade rom-monitor preference, rommon-...

Hi folks,someone could help me?1- How can I do a configuration of etherchannel in switch 2900XL (C2900XL Software (C2900XL-C3H2S-M), Version 12.0(5)XU)?Or wich paper show how can I do this etherchannel works between 2950G e 2900XL?2- If I do ethercha...

HiI have two Catalyst 3550 connecting two datacenter and I'm receiving errors on connecting switchports. Errors are output buffer failures and underruns. Is it just that switches are running out of resources or what? We are using servers in the datac...

i've managed to set up port security and i need to lock the ports down by one mac well after going through each port step by step all the mac's are in the table but it shows them as dynamic address's i thought they were supposed to be static secure? ...

Summary of the setup :-----------------------A multicast video trafic is generated within a layer-3 network. Switches CD1 and CD2 are Distribution Layer switches of a user Block. Under normal condition, CD2 is the PIM designated router on the hence ...

Hi,Is it possible to send tagged frames on a switched port which is configured as access with the VLAN ID equal to the native VLAN to do VLAN Hopping ???What are the best practices to avoid VLAN Hopping ????

I have a 6506 with a WS-X6148-GE-TX module and two servers running my Windows Active Directory. These two servers have 10/100 Ethernet Cards, and for some reason we are loosing connectivity to them. We have tried hardcoding the speed and duplex setti...

Hi to allI hav some problem with some option in the following qustions, I think all the options are true but the book says something else , So Please answer these question with little bit explaination. Question 1In network running link state protocol...

Hi,I have 7603 router with 2-ws6516-ge-tx cards (disk0:/c6k222-pk9sv-mz.122-18.SXD2.bin). I want to use card 1 as a swithcport. I enable trunk on port1 & it does not work with c3750. Trunking on cisco 3750 works o.k. with 3500XL switch.Following is ...