Microflow Policing on L3 port

[kkalaycioglu]

I'm trying microflow policing on Sup720/6500. Appliying inbound service policy to L3 subif (e.g. Gi13/8.2 with Ip address etc. configured). Is there any limitation for this config? It doesn't work as far as I see with "sh mls qos ip ", "sh mls qos" commands.

[mchin345]

The Supervisor 720 supports ingress policing on a port or VLAN interface. It supports egress policing on a port or L3 routed interface (in the case of Cisco IOS System Software). All ports in the VLAN are policed on egress regardless of the port QoS mode (whether port-based QoS or VLAN-based QoS). Microflow policing is not supported on egress.

For more information :http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00801c8c4b.shtml