Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
1. R5, R4, R1 are forming a FR hub and spoke topology R1 is hub. All three interface are physical.2. IP-FR mappings are static. on hub there are two maps each for one spoke with keyword broadcast. On spokes there are two maps one pointing the hub wit...
I'm trying microflow policing on Sup720/6500. Appliying inbound service policy to L3 subif (e.g. Gi13/8.2 with Ip address etc. configured). Is there any limitation for this config? It doesn't work as far as I see with "sh mls qos ip ", "sh mls qos" c...
Thanks for your reply. Let's suppose this scenario:Host A with MTU 9000 set, connected to a switchport jumbo enabled. Host B MTU 1500, on an vlan other than Host B.Those vlans ended on a 6500. What aboutthis communication? What may go wrong?Regards.
I've solved the issue. Instead of converting L3 interface to L2 using "switchport" command or deleting the subifs using no command if you enter subif conf mode and delete encapsulation command using "no encap dot1q 40" and then issue "switcport" comm...
No crash, these are syslog messages and I think the same way you do. There's something left in the memory about subif - vlan config. But I want to know if there's a workaround without reloading the switch.Regards.
