08-12-2004 09:55 AM - edited 03-02-2019 05:43 PM
Hello,
When I do a sh control s0/0. I am seeing the following at then end of the read-out.
PowerQUICC SCC specific errors:
28875 input aborts on receiving flag sequence
0 throttles, 0 enables
0 overruns
0 transmitter underruns
0 transmitter CTS losts
2427 aborted short frames
What exactly do these errors relate to?
Thank you for your help.
08-20-2004 01:05 PM
You may use the Output Interpreter tool available on the www.cisco.com/tac to interpret the sh controllers command output.
12-07-2004 03:07 AM
Hello,
I have a same issue about this counter.
I didn't found any informations about this.
Do you have found any informations about this counter :
input aborts on receiving flag sequence
Many thanks for your reply
Best Regards,
Christophe/
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide