Other Network Architecture Subjects

Would just like some advice on wide area networking. How would 3 LANS communicate with each other over the internet with routers if private ip addresses were assigned to LAN devices/routers. Would some sort of NAT be employed. I'm not really sure....

Folks. I'm a little lammer on switches'configuration. I just bought a Catalyst 3560 and went to configure it. I realized that after the first configuration when I issued the sh run command I saw a lot of configuration that I had not done. The IOS...

Hello,When I do a sh control s0/0. I am seeing the following at then end of the read-out.PowerQUICC SCC specific errors:28875 input aborts on receiving flag sequence0 throttles, 0 enables0 overruns0 transmitter underruns0 transmitter CTS losts2427 ab...

Hi,We have few vlans created and also have a mix of 3548 and 2548 switches, also we have 6009 as central switch with MSFC. Users of VLAN 4 complain of high latency when they access the VLAN 1 servers. We use PVST. Also , the truncking protocol is bot...

What's The effect of 4470 MTU size on the WRED threshold and queue lengths? Thanks in advance

Hi, can i know is it possible to limit only inbound/outbound traffic on the interfaces.Eg, i have a cisco 2600 with 2 FastEthernet interface. I want to limit my Fasteth 0/0 to only upload traffic and FastEth 0/1 to download traffic.Is there any solut...

Hi, we're currently running cisco 2611 router. The problem is duruing busy hour many users try to download stuff from the internet at the same and that take alot of our bandwidth, that also slow down other user surfing the web. What i would like to d...

Hi, I have one Cisco router with two T1 lines to different isp and running bgp on the same. I have configured the router to get the udpates from the directly connected route likeIp as-path access-list 10 permit ^$ip as-path access-list 20 permit ^isp...

Hi AllWe're trying to span multiple VLAN's over two Catalyst 3524's. We've used VTP to mirror the VLAN setup/database on both switches and connected the switches using an ISL Trunk. The VLAN's work but the problem arises when data travels over the IS...

I need to reset my router to factory defaults and dont know how could I get someone to walk me through the prossess.MIke Gaeta

Good Day,I've got an older 4500 router. I'd like to upgrade the ios so that it can function as a dhcp server and implement nat.If possible, how do I go about doing this?Thank You

Hello,Quick question here we have a 2610 set up to use 2 T1's bonded for Multlink PPP with our ISP. If we unplug 1 T1 the whole bundle drops, even though the 2nd T1 is still up / up. Their IS supposed to be redundancy right?

Hi, allthese days keep thinking a foolish question, why we need WAN?differenct country's people can communicate with each other also without WAN by subscribing different service provider, then why we still need WAN?don't blame me for asking such a qu...

Environment:6500-Switch-1, switch port 2/16 connected to 6500-B port 1/1, port 1/2 vacant (active sup. slot 1, port 1/1 forwarding)6500-Switch-2 switch port 2/16 connected to 6500-B port 2/1, port 2/2 vacant (standby sup. slot 2, port 2/1 blocking)Qu...