Need some help with an error message i see in the following router Cisco A901-4C-F-D

[lou.deroma@zayo.com]

Recently saw this message in the log of a Cisco 901

_soc_xgs3_mem_dma: FP_COUNTER_TABLE.ipipe0 failed(NAK)

Has anyone seen this before? What causes this and how do i go about resolving this?

[lou.deroma@zayo.com]

Not one reply? Interesting

[Dan Lukes]

You placed your question in community dedicated to other topics. You should not expect valuable answer here. I will move it for you to more appropriate place.

[lou.deroma@zayo.com]

Thanks Dan

[Dan Lukes]

It look like a hardware failure (it's DMA error during communication with a module). But sometime it may be just software issue. Or, issues like this one may be caused by excessive electromagnetic noise (comming either from mains or from a data cable).

Power cycle the switch. If it will not help, then consider it hardware failure.

[lou.deroma@zayo.com]

Thanks for the information