I have one 7606 running Version 12.2(33r)SRD6. We are trying to poll netflow for our solarwinds software. Solar wind is only able to see MSFC entries (telnet, snmp and ssh etc), PFC entries are not being shown.
Our configurations are as following...
!
ip flow-egress input-interface
ip flow-cache timeout active 1
!
mls flow ip interface-full
no mls flow ipv6
mls nde sender version 5
!
ip flow-export source Loopback0
ip flow-export version 5
ip flow-export destination x.x.x.x 2055
!
interface GigabitEthernet1/1
bandwidth 400000
ip address x.x.x.x x.x.x.x
no ip redirects
no ip unreachables
no ip proxy-arp
ip flow ingress
service-policy output TR-OUT
We have provided "ip route-cache flow" on interface g1/1 and in show run / show run all this command is not appearing.
We are getting following out put
7606# sh ip cache flow
-------------------------------------------------------------------------------
MSFC:
IP packet size distribution (580854 total packets):
1-32 64 96 128 160 192 224 256 288 320 352 384 416 448 480
.000 .066 .401 .001 .077 .026 .110 .017 .029 .000 .000 .002 .000 .021 .196
512 544 576 1024 1536 2048 2560 3072 3584 4096 4608
.046 .000 .000 .000 .000 .000 .000 .000 .000 .000 .000
IP Flow Switching Cache, 278544 bytes
2 active, 4094 inactive, 165962 added
2747752 ager polls, 0 flow alloc failures
Active flows timeout in 1 minutes
Inactive flows timeout in 15 seconds
IP Sub Flow Cache, 34056 bytes
2 active, 1022 inactive, 165962 added, 165962 added to flow
0 alloc failures, 0 force free
1 chunk, 3 chunks added
last clearing of statistics never
Protocol Total Flows Packets Bytes Packets Active(Sec) Idle(Sec)
-------- Flows /Sec /Flow /Pkt /Sec /Flow /Flow
TCP-Telnet 1 0.0 1 40 0.0 0.0 16.2
TCP-FTP 1 0.0 1 40 0.0 0.0 16.2
TCP-FTPD 1 0.0 1 40 0.0 0.0 16.2
SrcIf SrcIPaddress DstIf DstIPaddress Pr SrcP DstP Pkts
TCP-WWW 1 0.0 1 40 0.0 0.0 15.9
TCP-SMTP 1 0.0 1 40 0.0 0.0 15.2
TCP-X 1 0.0 1 40 0.0 0.0 15.7
TCP-BGP 1 0.0 1 40 0.0 0.0 15.5
TCP-NNTP 1 0.0 1 40 0.0 0.0 15.7
TCP-other 4176 0.0 5 57 0.0 1.8 7.7
UDP-NTP 29789 0.0 1 76 0.0 0.0 15.5
UDP-other 67521 0.0 6 254 0.1 1.1 15.4
ICMP 64466 0.0 1 72 0.0 0.6 15.4
Total: 165960 0.0 3 215 0.1 0.7 15.3
SrcIf SrcIPaddress DstIf DstIPaddress Pr SrcP DstP Pkts
Gi1/1 x.x.x.x Local x.x.x.x 06 0B72 0016 79
Gi1/1 x.x.x.x Local x.x.x.x 06 0031 D687 5
-------------------------------------------------------------------------------
PFC:
Displaying Hardware entries in Module 5
SrcIf SrcIPaddress DstIPaddress Pr SrcP DstP Pkts
-- 0.0.0.0 0.0.0.0 0 0 0 2773354
show module 1
7606#sh module 1
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
1 24 CEF720 24 port 1000mb SFP WS-X6724-SFP
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
1 588d.097c.5f18 to 588d.097c.5f2f 5.0 12.2(18r)S1 12.2(33)SRE6 Ok
Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
1 Centralized Forwarding Card WS-F6700-CFC 4.1 Ok
Mod Online Diag Status
---- -------------------
1 Pass
show module 5
7606#show module 5
Mod Ports Card Type Model Serial No.
--- ----- -------------------------------------- ------------------ -----------
5 5 Route Switch Processor 720 10GE (Activ RSP720-3C-10GE
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
5 68ef.bdd3.36ac to 68ef.bdd3.36b3 1.0 12.2(33r)SRD 12.2(33)SRE6 Ok
Mod Sub-Module Model Serial Hw Status
---- --------------------------- ------------------ ----------- ------- -------
5 Policy Feature Card 3 7600-PFC3C-10GE 1.1 Ok
5 C7600 MSFC4 Daughterboard 7600-MSFC4 2.2 Ok
Mod Online Diag Status
---- -------------------
5 Pass
Any help will be highly appreciated...
Best Regards,
