Netflow on Catalyst 6509

[mark.walker]

I have Catylyst 6509 with the following:

c6sup2_rp-PK9S-M, Version 12.2(17d)SXB1

Policy Feature Card 2

Cat6k MSFC 2 daughterboard

I'm looking to capture netflow traffic to my pix firewall port 3/12 vlan 40. 1.Is that possible? 2. if so does anyone have a configuration that would work in this scenario?

thanks

[Mark Turpin]

Yes, it is possible. Check out:

http://www.cisco.com/en/US/products/hw/switches/ps700/products_configuration_guide_chapter09186a008007fa2b.html

BTW, make sure you turn on MLS full flow to get all the details.

I'd recommend OSU Flow-Tools available at:

http://www.splintered.net/sw/flow-tools/

HTH,

-Mark

[mark.walker]

Hello Mark, thanks for the information....I think I'm close, but I'm still not getting the right results. All the flows are there from the switches perstective,the collector is working or it appears to be, but my traffic volume should be much higher than what's indicated. Any ideas as to where else to look?