03-17-2004 05:59 PM - edited 03-02-2019 02:21 PM
Hi
We got 2 routers routerA and routerB running OSPF as routing protocol. what we want is routerA to send all the routing tables to routerB but we dont want routerB to send updates or limited updates to routerA. can someone tell me that is it possbile, if yes can you help me.
Thanks
03-17-2004 06:41 PM
Sure, just use route-maps to allow or deny whatever routing updates you want...
Here's a good link...
03-18-2004 04:05 AM
Distribute lists and route maps will only block routes from being placed in the routing table of the local router, they won't prevent the routes from being readvertises to an adjacenct neighbor, for instance.
There are only a couple of ways to block routes between two routers, and both of them require B to be an ABR. The first is what Herald mentioned, making B an ABR, and A part of a totally stubby area. The other would be to make B an ABR, and use type 3 filtering to block the routes being sent to A (this would work whether A is part of area 0 or some other area outside te backbone).
http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a00800b5d4f.html
You could also, using this feature, make A an ABR and filter the routes inbound, as long as they are type 3's (which isn't likely). If the routes are externals, you can still use the stubby area trick, or you can make B an ABR, summarize the routes, then block the summaries with the type 3 filtering above.
Hope that helps...
:-)
Russ.W
03-18-2004 11:48 AM
There are 2 other ways that you could accomplish this with out having to change your ospf network type. You could use the command "ip ospf database-filter all out" under the interface on Router B to filter all LSA's from being sent out that interface, or you could use the command "neighbor x.x.x.x database-filter all out" under the ospf config of router B to just filter out LSA's to thatspecific neighbor
03-17-2004 06:42 PM
You could configure router B as an ABR and configure the interface to router A as part of a totally stibby area. This way B would receive all networks from router A and A would only receive a default route from router B.
Hope this helps,
03-17-2004 07:08 PM
nittinigam you can follow hitter points .
it will work
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide