Hi all!
Chassis is 7206VXR w. NPE-G1 running 12.2(13)ZD1.
PA-E3 works fine there, but when I try to configure individual ports or IMA groups on PA-A3-8E1IMA, it shows :
-Traceback= 604595F4 6068A7F0 60689E08 60689A60 60641264 60653FF4 606C9934 606C9920
loki_reset(ATM6/ima2): state=0 status=0x44218000 oir_flags=0
atm: config_status 0, flags 0x48000
loki_disable(ATM6/ima2): config_status 0, flags 48000
loki_shutdown(ATM6/ima2): state 0 newstate 6
Resetting ATM6/ima2
loki_enable(ATM6/ima2): state 0 atm config_status 0, flags 48000
loki_pas_restart(ATM6/ima2): state 0
ILMI(ATM6/ima2): Received Interface Down. Shutting down ILMI
With hardware loopback plugged in, green light up, but 'show controller ATM' says all down.
With 'loopback diag', Facility Alarms show 'Loopback is on', but controller doesn't come up.
Brand new Software Advisor recommends a lot of IOSes that must support this hardware - 12.2(13)ZD1 is the second in the list
(first - 12.2(13)ZE - is not present on ftp for 7200 platform :)
I've tried 5 or 6 releases, from 12.1 to 12.2, with same results.... Faulty board ?