Packet tracing in a uBR7246

[jcasqueiro]

Hi there !

As I am loosing some TCP/IP cnxs between remote cable workstations and a set of W2K servers, I would like to trace the TCP/IP flow on the access CMTS (uBR7246) for a specific MAC address (if not, for a specific IP although it is more difficult as it is dynamic).

Someone told me that it was possible to command the uBR to do wire tapping on a specific mac address and send the trace to a specific IP. If this is true how can I do it ?? If not, are there any suggestions ??

Thanks/Brgds

jc

[murabi]

Wiretap Support is a cable CMTS feature that is supported on the Cisco CMTS universal broadband routers.This feature offers an interception (wire tapping) mechanism such that user-to-user traffic within a single CMTS can be captured to meet requirements in countries where regulatory issues mandate a method by which law enforcement agencies can view all traffic to and from an individual subscriber.

You can go through the following URL:

http://www.cisco.com/en/US/products/hw/cable/ps2217/products_command_reference_chapter09186a0080108e8f.html#30545

[jcasqueiro]

Thanks for the tip Murabi !

Brgds

jc