PAT traffic

[sayeed]

Hello,

I have a router Cisco 801, it is connecting to internet using bri0 and gets a dynamic ip. Is there a NAT command which will allow all the traffic coming to ISDN port to be natted to some ip on the inside network.

Above requirment comes because, I have a pix 501 which is behind cisco 801, i need to connect to pix outside ip for vpn from outside, my dynamic ip does not change very often.

Regards,

Sayeed Alhajri.

[rais]

Your router supports VPN:

http://www.cisco.com/en/US/products/hw/routers/ps380/ps4003/index.html

You should be able to tunnel to your internet IP address. The router will then assign you an IP address from its pool. Simply allow this address to access internal network through the firewall.

Hope this helps.