POWER question cat 4000 10/100/1000 blade

[e.maloney]

Two part issue,

Does anyone know what the part number is for a Cat 4000 AC power supply? Can only find supplies for the new 4500. Is it the same power supply?

I'll be setting up a cat 4003 with two new 10/100/1000 blades, part # WS-X4448-GB-RJ45. Once I get the second power supply (above), Do I need to upgrade my IOS?

any input, thanks!

[cminch]

Hi,

Here the part number: WS-X4008=

For the Upgrade part you did not mention which OS you are running. The Modules is supported with a minimum of 12.1(8a)EW.

Regards,

Corey

[e.maloney]

Thanks Corey. I should mention I have a Cat 4003 with CatOs 5.2(1). 5.5(18) is out now. I will most likely upgrade to that version before I insert the cards.

Thanks much.

- Ted

[Bobby Thekkekandam]

the WS-X4448-GB-RJ45 requires a minimum CatOS of 7.1.1a and the recommended version is 7.4(3) or later.

you can use the release notes to check hardware software compatibility.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/relnotes/ol_1983.htm

hope that helps,

Bobby

[e.maloney]

Ah ha, I see I am quite a few revs behind. Not my fault, inherited network ;)

Thanks for the input. I'll investigate the caveats of the revs.

- Ted