Power supplies in redundant or load balance mode?

[nvamvakas]

A quick question:

When a 4506 switch is installed with two power supplies, by default they operate in redundant or load-balancing mode?

thank you

Nikolas

[pflunkert]

Hi Nikolas,

By default, a switch is set to redundant mode. In the show power command, if the power supplies needed by system is 1, the switch is in redundant mode; if the power supplies needed by system is 2, the switch is in combined mode.

URL: http://www.cisco.com/en/US/partner/products/hw/switches/ps4324/products_configuration_guide_chapter09186a00802c3261.html

or

http://www.cisco.com/en/US/products/hw/switches/ps4324/products_configuration_guide_chapter09186a00802c3261.html

Regards

Peter