Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,we have a big network with nearly 1000 routing entries. When i made a "show ip route" i can saw that the 95% of the entries are "new".Example:O IA 198.0.140.0/24 [110/103] via 10.26.4.29, 00:05:00, Vlan11O 4.192.198.0/24 [110/4] via 10.26.6....
Hi,you can determine the active switch with the "show switch" command.When you are connected to a console you see this:#sh switch CurrentSwitch# Role Mac Address Priority State--------------...
Hi,first i missed the "mls qos" command, but i assume that you only forgot to wrote it here ;-))Try the configuration with a any any acl. Only to the traffic you specify, the rate limit will works.RegardsPeter
Hi, i hope i understand you...The simplest way is that:username user1 password password1line vty 0 4 login localThen the user must use a username/passowrd combination to login.RegardsPeter
Hi,ISL is proprietary, you should use IEEE 802.1q.The Differences between both protocols you will find here:http://www.cisco.com/en/US/partner/tech/tk389/tk390/tsd_technology_support_protocol_home.htmlRegardsPeter
