After the PPPoE negotiation was completed,
two addresses connected in Dialer can be found on the routing table.(like the following)
192.168.1.0/32 is subnetted, 2 subnets
C 192.168.1.1 is directly connected, Dialer1
C 192.168.1.240 is directly connected, Dialer1
I guess one of them is assigned for this router,
and the other is PPPoE-server's.
Is there any way to let PPPoE-server's not to be seen on the routing table?
Maybe this router received the PPPoE-server's IP address through IPCP, but I'd like the router not to accept that.
Does anyone have an idea?
Regards
