11-15-2002 02:21 PM - edited 03-02-2019 02:55 AM
Trying to upgrade 3640 IOS from IP (c3640-i-mz.122-5d) to IP Plus. Router has 32mb memory, a 1FE2W network mod and a WIC-1DSU-T1 card. Release notes say I have enough memory, however when I upgraded via tftp with c3640-is-mz.121-5 or c3640-is-mz.120-13 and do a show interfaces, there are no interfaces displayed and of course there are no interfaces for me to configure. Any suggestions would be greatly appreciated. Thank you.
D. Evans
11-15-2002 02:43 PM
Looks like the code you loaded (12.1.5 and 12.0.13 Mainline) do not support your 1FE2w module and this is most likely why you're not seeing anything interfaces. The following is minimum required for this module.
12.0(7)XK, 12.1(1)T, 12.1(5)YB, 12.1(5)YD, 12.2(1), 12.2(2)T, 12.2(2)XT,
12.2(8)T
For future inquiries into HW/SW support issues please see the following URL.
http://www.cisco.com/cgi-bin/front.x/Support/HWSWmatrix/hwswmatrix.cgi/
Hope this helps,
Don
11-18-2002 05:54 AM
Thanks Don, guess I shouldn't assume that what I get through distribution is necessarily the correct rev.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide