problem with a priotrity list

[correa]

Hi,

I have a router 2620 and i want to give him some priority on some flow. So i decide to use the priority-list command, but that don't seem to be good.

I try to use a netmeeting between 2 compueter. For see if it's work i launch a some ftp for test if the priority list make his job.

This is my command tha i enter:

(config)#priority-list 1 protocol ip hight udp 7648

(config)#priority-list 1 protocol ip hight udp 24032

(config)#priority-list 1 protocol ip hight udp 56800

(config)#priority-list 1 protocol ip low tcp 21

(config)#priority-list 1 default normal

(config)#int fast 0/1

(config-if)#priority-group 1

I don't know why but the netmeetin lag, and i think that the priority list doesn't work

So i try the commande

#debug priority

And nothing go on my screen

Thanks for your answer

[rjackson]

Is there only one router or is there another one on the ohter side of a wan link? Did you set priority there too?

[correa]

Hi,

Oups i forgot, yes there is another one on the other side, this is the same router (2620) and i set the same priority on the 2 router.

I set priority on the interfaces which establishes the link between the 2 routers