Solved: Re: question for spanning-tree

shsong21 · ‎02-26-2005

Hi....all

The following sample output is my a cat4506

missile_site#sh spanning-tree vlan 10

VLAN0010

Spanning tree enabled protocol ieee

Root ID Priority 32768

Address 00e0.637f.4a8c

Cost 19

Port 280 (FastEthernet5/24)

Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec

Bridge ID Priority 32778 (priority 32768 sys-id-ext 10)

Address 000b.befd.b600

Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec

Aging Time 300

Interface Role Sts Cost Prio.Nbr Type

---------------- ---- --- --------- -------- --------------------------------

Gi2/1 Desg FWD 4 128.65 P2p

Gi2/3 Desg FWD 4 128.67 P2p

Gi2/4 Desg FWD 4 128.68 P2p

Gi3/1 Desg FWD 4 128.129 P2p

Fa5/7 Desg FWD 19 128.263 P2p

Fa5/9 Desg FWD 19 128.265 P2p

Fa5/10 Desg FWD 19 128.266 P2p

Fa5/19 Desg FWD 100 128.275 Edge Shr

Fa5/23 Desg FWD 100 128.279 Shr

Fa5/24 Root FWD 19 128.280 P2p

Fa5/27 Desg FWD 100 128.283 Shr

Fa5/31 Desg FWD 100 128.287 Shr

---------------------------------------------------

what do you know for p2p ?

what does 'p2p' ?

i'm wait answer.....

Thanks....

in South Korea

alagrawa · ‎02-26-2005

Hi, Thanks for writing in.

P2p means Point to point link. The switch determines that it is a point to point link if the link is a full duplex link.

Shr means shared. The switch determines that a port is a shared port if the port is a half duplex link.

Edge: A switch determines that a port is an edge port if the port is configured for spanning tree portfast.

Hope that helps.

regards

-Alok

View solution in original post

alagrawa · ‎02-26-2005