"show environment temperature"

[russemerson]

The output I'm getting from my 4506 doesn't match the command output documented in the command lookup tool.  I'm seeing:

B31450604#sh env temp

Module Sensor                     Temperature          Status     

------+--------------------------+--------------------+------------

1      air inlet                  38C (51C,65C,68C)              ok

1      air outlet                 50C (69C,83C,86C)              ok

2      air inlet                  35C (45C,60C,70C)              ok

2      air outlet                 45C (61C,76C,86C)              ok

3      air inlet                  34C (45C,60C,70C)              ok

3      air outlet                 42C (61C,76C,86C)              ok

4      air inlet                  35C (45C,60C,70C)              ok

4      air outlet                 45C (61C,76C,86C)              ok

5      air inlet                  35C (45C,60C,70C)              ok

5      air outlet                 44C (61C,76C,86C)              ok

6      air inlet                  36C (45C,60C,70C)              ok

6      air outlet                 43C (61C,76C,86C)              ok

What I don't see in the documentation is the meaning of the values within the parentheses.

Would I be wrong to think that it's historical data?

If it is, what's the interval?

[smehrnia]

Hi,

I believe what you see in parentheses are: (Normal Temp, Over Temp Threshold, Critical Temp Threshold)

plz Rate if it helped.

Soroush.

[handoko wiyanto · Accepted solution]

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/53SG/configuration/pwr_envr.html

check on "Conditions on Supervisor Engine 6-E "

it says ... These linecards support three thresholds: warning, critical, and shutdown.