Buy or Renew
Buy or Renew
russemerson
Level 1
Level 1
Member since ‎06-17-2012
‎08-18-2017
Recent Badges

User Statistics

  • 4 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
See all
First Discussion
5 Helpful Vote
1 Helpful Vote

User Activity

LACP: "Unknown packets rcvd" and "Illegal packets rcvd"?

04-20-2014
While troubleshooting an issue on an N5K, we noticed the following values in the output of the "show lacp" command: bld-vda-4a-d33231# sh lacp interf eth 125/1/9[snip]  Unknown packets rcvd: 1303  Illegal packets rcvd: 1303 We have not been able to f...

No tunnels configured, but frequent log messages, "%LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel1, changed state to up"

04-13-2014
ASR 1002 running 12.2(33)XND3.  We're seeing the %LINEPROTO-5-UPDOWN log message every 5 to 15 minutes, always "changed state to up" despite there never having been any tunnel interface configured on the box. Additionally, we do get output from the "...

ip bandwidth-percent eigrp - - percentage over 100?

10-19-2012
I note that the IOS Command Lookup Tool states that for the "ip bandwidth-percent eigrp [AS] {percent]" command, values greater than 100 percent may be configured.Indeed, the parser shows:Router(config-if)#ip bandwidth-percent ei 1000 ?  <1-999999>  ...

"show environment temperature"

06-17-2012
The output I'm getting from my 4506 doesn't match the command output documented in the command lookup tool.  I'm seeing:B31450604#sh env tempModule Sensor                     Temperature          Status      ------+--------------------------+--------...
Community Statistics
Member Since ‎06-17-2012 03:10 PM
Date Last Visited ‎08-18-2017 03:55 AM
Posts 4
Total Helpful Votes Received 5
Helpful Votes From
See all >