03-24-2003 01:23 PM - edited 03-02-2019 06:06 AM
How do you implement "rate-limit" on a Cat3550 in front of an ONS 15454 so I can limit client access to specific bandwidth (i.e. Client-1 10Mbps, Client-2 45Mbps, and Client-3 to 30Mbps)?
03-28-2003 02:07 PM
There was another thread running in the forum regarding limiting the bandwidth on the ports of the switch. You could refer to the same.
http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Ddisplay_location%26location%3D.ee92c7b
In short, rate limiting is possible with serial ports and not on ethernet.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community