cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
335
Views
0
Helpful
1
Replies

Reflected Multicast not showing on my vrf Rendezvous Point

PSharona
Beginner
Beginner

Hi, im wondering if this architecture is even possible. I have 2 routers R1 and R2. R1 is the RP and is connected to R2. Im using sparse mode to pull the multicast feed from the RP to R2 and reflected with a new Multicast group via a Virtual Interface. Now the tricky part im having is R1 has a vrf OUT which the new Multicast group is suppose leave. I placed a RP on the vrf OUT but im not seeing the new source on the vrf RP. Also R1, R1 vrf OUT, and R2 are all in the same network. Is possible for R2 to have 2 RPs?

1 Reply 1

paul driver
VIP Expert VIP Expert
VIP Expert

Hello

Can you post a topology diagram please.


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: