REMSH and Router Configuring - Is it possible?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-05-2002 05:35 AM - edited 03-01-2019 09:11 PM
Hi, guys.
I want to perfom some configuration editing automatically in depend of some events. I've found out how to process events and now ready to configure.
But with REMSH from unix machine I can execute only "sh" commands :( Is there the way to change confguration via such a tool?
Regards,
Alexander.
- Labels:
-
Other Networking
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-05-2002 05:41 AM
I think this is what you're asking for.
"ip rcmd rsh-enable" is briefly explained on this link.
Mick.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-05-2002 06:17 AM
Thanks Mick,
my fault was to use short commands like "conf t" - it's a habbit :)
It does really work.
Regards,
Alexander.
