Replacing cisco 1603 with 2612.

[SAM ANANDARAJAH]

at present the set up is :256K cct ------MUX-------IN -------OUT------(4) RJ45 VOICE PORTS.

FROM OUT :wan connection to Cisco 1603 router.

what the customer wants is:

maintain the voice mux.

can I replace the 1603 ,with 2612.? will the mux need to be configured ?

will the voice call be affected.?

Thanks

Sam

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.