rommon and router boot problem

[mikejr]

I accidentally blew up the IOS on my router. After some messing around, I was able to use TFTP to copy it back to the flash card. So now I have the IOS file back on the flash card, but I can't make it boot from it.

I had to clear the config-register 0x0 to get to the rommon. I think I have to replace the correct file to boot off of at 0x0, but I'm confused as to what those config-register commands do.

Please tell me how I can make it boot from the file off the flash: filesystem. Also if anyone feels energetic, please give me a mini explaination of the config-registers.

[amdcent]

Go to

http://www.boson.com/promo/utilities.htm

and download "Confreg Calculator" will help you fix your problem.

-amdcent

[eapenten]

You may visit the links below for more information on config-register. I hope this helps in a way.

http://www.cisco.com/warp/public/108/hwts_1700_17959.html

http://www.cisco.com/warp/public/63/lose_config_6201.html

Regards,

Emil

[prasanthpk]

friend

i am also having almost the same problem

i am from a cisco partner and to meet cisco person for this small thing is a bit of shame isn't it

i think u has got answer for u r problem

i u can help me with ref to u r solution pls help me

now i will tell my prob.

my router always boots from rom instead of flash

i checked my config reg every thing is correct

i tried to load a new ios but now the flash tells it is read only.my router is 2500 and now it is in my customer site

u can chat with me on prasanthpk78@yahoo.com

hpoe to meet u there now

prasanth