Hi..I have 5300 and i got new 5400 now i can't see the commands which i used to have it for mica..Can i have a place where i can find the commands like mica for Nextport..Thx..
I have a 7206VXR with a Multichanel T-1 port adapter, PA-MC-2T1. Can I use this for my T-1's to my upstream bandwidth providers? It has built in CSU/DSU so I'm thinking I can. Also when I boot up the router I cannot see the interfaces, the ports sho...
I want to disable users from dialing new call into my 3640 with MICA modems, but I don't want to disconnect any of the call currently open. Could I just enter a "no isdn incoming-voice modem" on the serial interface?
From this documents on CCO:Sample Configuration:Channeling,Trunking and HSRP Betweenn Catalyst 6000 Switches Running Hybrid CATOS/IOS and Native IOS, there are somes Important Notes.One of his says to be sure the native VLAN matches on each 802.1q tr...
I would like to plan an backup policy to the data links and i got some questions:1) The E1 controller of Cisco AS5300 works like modems for dial conections ?2) How could i configure an Cisco 1750 AUX port to work like an dial-bakup? What kind of mode...
We have CNR at our site. However, We are running them as stand alone server on serving the same scope. What is the best way to implement CNR? The second question I have is as follow. What is the draw back to managing multiple clusters from one client...
I am trying to figure a way to use a virtual interface, or rotary type config on a 3640 to do reverse telnet to the next available modem port, instead of specifying a specific modem port, and then issue AT commands to dial a pager.
I have a router with a Leased line and ISDN, both connected to one ISP. I want to load balance the traffic between LL and ISDN when the traffic in the LL is high. For that all the necessary configuration was done at my end router and at the ISP sid...
Hi,I was reading in the Cat6K software configuration guide (Rel6.3) that the PFC2 has a (very wierd) limitation: page22-27 "The PFC2 supports a maximum of 16 unique HSRP group numbers. you can use the same HSRP group numbers in different VLANs. ..."C...
Hi I'm Giuseppe Pratola , i work in Getronics , position: Network admin.My problem is this , after read this advertisment, i need upgrade the switch:"For the switches above, the following CatOS-based switch software revisions are vulnerable.Catalyst ...
What I am looking for is a basic testing template (check list). We are always implementing new products i.e. the Catalyst 6513. This checklist needs to encompass testing of chassis, blades, and network connectivity. This is basically for management...
I had several ports on three different 3548s in the same IDF set back to the default VLAN. I did not see any errors at the 6509 or the 3548s. Not all ports on the switches changed but all that did were linked to HP Jet Direct print servers. I reca...
we hv 10.10.X.254 Network where X starts from 1 to 50(which has connected to 2948gL3).One of the port in L3 has connected to Storage device.How can i take backup for all the connected m/c.some of them are mail servers..48th port of L3 is connected to...
