Setting up a VPN over a DSL link using dialer lists

[marcjone]

Hi all

I am trying to set up a VPN from my ADSL router (837) using a dialer-list based on the desitination IP address i.e. the VPN should run between my router and a Pix

Can anyone suggest a sample configuration, or direct me to a link which explains the requirements for this in detail ?

Many thanks in advance for any help

Kind regards

Marcus

[paddyxdoyle]

Marcus

The following link shows how to configure an IPSEC VPN from a 7200 router to a PIX.

You should be able to doctor this and apply it to your setup.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080094498.shtml

HTH

Paddy

[Georg Pauwen]

Hello Marcus,

in addition to the previous post, you might also want to check out the Cisco IPSec Technology Page. Scroll down to the sections ´IPSec on Router to PIX´ and ´IPSec on Router to Router --> Configuring a Cisco 827 for PPPoE with VPN IPSec NAT Overloading´.

TECHNICAL SUPPORT

IPSec (IP Security Protocol)

http://www.cisco.com/cgi-bin/Support/browse/psp_view.pl?p=Technologies:IPSec&s=Implementation_and_Configuration#Samples_and_Tips

Regards,

Georg

www.solutionfinders.nl

[a.awan]

Both the above posts do provide you with enough information to allow you to configure a VPN between a router and a PIX. I will just provide you with a link that shows how to configure IPSec between two routers over a DDR link. You can use the DDR portion of the configuration and apply it to your scenario along with the information from the previous posts.

http://www.cisco.com/en/US/tech/tk801/tk133/technologies_configuration_example09186a0080093c09.shtml

[marcjone]

Many thanks Paddy, Georg and Atif - I have no experience of setting up VPN's so this information is much appreciated :)